Power switch and DC barrel plug support - for Kite's SAIO
If you want to go for a clean build without glue, you can adopt this custom 3D printed part.
How does it work ?
- solder your wires to the DC barrel plug and to the switch.
- put a small piece of vhb tape under the switch and the DC barrel plug
- put the switch and the DC barrel plug in place and press them firmly down
- slowly push down the 3D part down to the top left of the rear half of the shell
- voila !
Designed for use with this DC Power Jack Socket Connector
and this High Side Toggle switch 2P2T 2 Position Slide Switch